Subject: RE: Attention Cervelo P2C and P3 owners There are two different xlab set ups. I'm using the aluminum xlab, whichever one is "flat," as in horizontal coming off the saddle. I got it to kinda work just by pulling the U's around the rails as best as possible and then tightening. I know some people hack the back hole off the carbon post but I just filed a notch in the top of the post where it comes in contact with the wing. It fits more secure now but I did notice yesterday when I was doing some saddle adjustments that it looks like the high position of the wing is bending in the seat rails a bit, making it hard to adjust the saddle aft. I'll probably file the notch a bit deeper to alleviate this. If yours is the one with two vertical "fins" coming out of the saddle, I've seen a couple of links on S'Twitch about folks who modified theirs one way or another. EC |